Starting Microloader ASM built on ??? 08 2015 09:37:26... Initializing PLLs... Initializing Clocks.. Initializing DDR PLLs/Clocks... Initializing DDR controller... Initializing data section... Initializing stack ptr... Switching to 'C' code... Starting Microloader C... Chip: APOLLO Found External Realtek 8211EG PHY on GMAC0 Checking for Guide button press ... GCS in ISA MODE GCS: SFC DEVICE SETUP COMPLETE MMC:No device found BOX MAC OK! BOX: Type: TANK Rev: 84900104 Setting up default ATAG list... Jumping to U-Boot ... BOOT_TIME: 1006 ms since POR -------------------------------------------------------------------------------- | U-Boot 2009.08-00067-gebbd4b2 (Apr 03 2015 - 16:35:07) CST HDx | |------------------------------------------------------------------------------| | Chipset information | | Vendor: NXP Type: Apollo Revision: M1 Fuses: 0015726F | |------------------------------------------------------------------------------| | Clock information | | *** not available yet *** | |------------------------------------------------------------------------------| | Frontpanel information | | Vendor: CST Version: 4.1 Display: OLED (256 x 64 px) | |------------------------------------------------------------------------------| | Memory configuration | | Start | End | Type | Description | |----------+----------+---------+----------------------------------------------| | 00000000 | 0FFFFFFF | RAM | System main memory bank #0 (256M) | | 20000000 | 2FFFFFFF | RAM | System main memory bank #1 (256M) | | D0000000 | D03FFFFF | S-FLASH | Eon Silicon EN25Q32 ( 4M / 64K x 64) | *** Warning - bad CRC or SFC, using default environment | 00000000*| 3FFFFFFF*| NAND | Toshiba NAND 1GiB 3,3V 8-bit | |------------------------------------------------------------------------------| | Network configuration | | MAC: LIP 6300 address: 00-C5-5C-56-34-29 | -------------------------------------------------------------------------------- Hit any key to stop autoboot: 0 SFC read: offset 0x100000, size 0x300000 3145728 bytes read: OK ## Booting kernel from Legacy Image at 01000000 ... Image Name: NI Apollo Kernel Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2969776 Bytes = 2.8 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Uncompressing Linux... done, booting the kernel. Starting Microloader ASM built on ??? 08 2015 09:37:26... Initializing PLLs... Initializing Clocks.. Initializing DDR PLLs/Clocks... Initializing DDR controller... Initializing data section... Initializing stack ptr... Switching to 'C' code... Starting Microloader C... Chip: APOLLO Found External Realtek 8211EG PHY on GMAC0 Checking for Guide button press ... GCS in ISA MODE GCS: SFC DEVICE SETUP COMPLETE MMC:No device found BOX MAC OK! BOX: Type: TANK Rev: 84900104 Setting up default ATAG list... Jumping to U-Boot ... BOOT_TIME: 1006 ms since POR -------------------------------------------------------------------------------- | U-Boot 2009.08-00067-gebbd4b2 (Apr 03 2015 - 16:35:07) CST HDx | |------------------------------------------------------------------------------| | Chipset information | | Vendor: NXP Type: Apollo Revision: M1 Fuses: 0015726F | |------------------------------------------------------------------------------| | Clock information | | *** not available yet *** | |------------------------------------------------------------------------------| | Frontpanel information | | Vendor: CST Version: 4.1 Display: OLED (256 x 64 px) | |------------------------------------------------------------------------------| | Memory configuration | | Start | End | Type | Description | |----------+----------+---------+----------------------------------------------| | 00000000 | 0FFFFFFF | RAM | System main memory bank #0 (256M) | | 20000000 | 2FFFFFFF | RAM | System main memory bank #1 (256M) | | D0000000 | D03FFFFF | S-FLASH | Eon Silicon EN25Q32 ( 4M / 64K x 64) | *** Warning - bad CRC or SFC, using default environment | 00000000*| 3FFFFFFF*| NAND | Toshiba NAND 1GiB 3,3V 8-bit | |------------------------------------------------------------------------------| | Network configuration | | MAC: LIP 6300 address: 00-C5-5C-56-34-29 | -------------------------------------------------------------------------------- Hit any key to stop autoboot: 3 Emergency update from usb (Re)start USB... USB: Register 10011 NbrPorts 1 USB EHCI 1.00 scanning bus for devices... 2 USB Device(s) found scanning bus for storage devices... 1 Storage Device(s) found reading uldr.bin ** Unable to read "uldr.bin" from usb 0:1 ** ** Skipping uldr.bin ** reading u-boot.bin ** Unable to read "u-boot.bin" from usb 0:1 ** ** Skipping u-boot.bin ** reading env.bin 0 bytes read SFC erase: offset 0xc0000, size 0x20000 OK SFC write: offset 0xc0000, size 0x20000 131072 bytes written: OK reading vmlinux.ub.gz 2969840 bytes read SFC erase: offset 0x100000, size 0x300000 OK SFC write: offset 0x100000, size 0x300000 3145728 bytes written: OK reading rootfs.arm.jffs2.nand 39112264 bytes read NAND erase: device 0 offset 0x0, size 0x10000000 Bad block table found at page 262080, version 0x01 Bad block table found at page 262016, version 0x01 Erasing at 0xffc0000 -- 100% complete. OK NAND write: device 0 offset 0x0, size 0x254ce48 39112264 bytes written: OK ** Invalid boot device ** ** Skipping rootfs1.arm.jffs2.nand ** ** Invalid boot device ** ** Skipping var.arm.jffs2.nand ** resetting ... Starting Microloader ASM built on ??? 08 2015 09:37:26... Initializing PLLs... Initializing Clocks.. Initializing DDR PLLs/Clocks... Initializing DDR controller... Initializing data section... Initializing stack ptr... Starting Microloader C... Chip: APOLLO Found External Realtek 8211EG PHY on GMAC0 Checking for Guide button press ... GCS in ISA MODE GCS: SFC DEVICE SETUP COMPLETE MMC:No device found BOX MAC OK! BOX: Type: TANK Rev: 84900104 Setting up default ATAG list... Jumping to U-Boot ... BOOT_TIME: 1006 ms since POR -------------------------------------------------------------------------------- | U-Boot 2009.08-00067-gebbd4b2 (Apr 03 2015 - 16:35:07) CST HDx | |------------------------------------------------------------------------------| | Chipset information | | Vendor: NXP Type: Apollo Revision: M1 Fuses: 0015726F | |------------------------------------------------------------------------------| | Clock information | | *** not available yet *** | |------------------------------------------------------------------------------| | Frontpanel information | | Vendor: CST Version: 4.1 Display: OLED (256 x 64 px) | |------------------------------------------------------------------------------| | Memory configuration | | Start | End | Type | Description | |----------+----------+---------+----------------------------------------------| | 00000000 | 0FFFFFFF | RAM | System main memory bank #0 (256M) | | 20000000 | 2FFFFFFF | RAM | System main memory bank #1 (256M) | | D0000000 | D03FFFFF | S-FLASH | Eon Silicon EN25Q32 ( 4M / 64K x 64) | *** Warning - bad CRC or SFC, using default environment | 00000000*| 3FFFFFFF*| NAND | Toshiba NAND 1GiB 3,3V 8-bit | |------------------------------------------------------------------------------| | Network configuration | | MAC: LIP 6300 address: 00-C5-5C-56-34-29 | -------------------------------------------------------------------------------- Hit any key to stop autoboot: 0 SFC read: offset 0x100000, size 0x300000 3145728 bytes read: OK ## Booting kernel from Legacy Image at 01000000 ... Image Name: NI Apollo Kernel Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2969776 Bytes = 2.8 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Uncompressing Linux... done, booting the kernel.